air handlers for factories

System Design The Monroe Spiral Tube Oil Mist Collector is a air two stage unit and does not require filter media for primary mist removal. The spiral tubes provide a high level of handlers mist agglomeration and removal without using filters. Centrifugal force and impaction provide the mechanism for mist removal. for Dirty air is propelled factories down several spiral air shaped impaction tubes handlers and a fluid for and factories film is created. The oil drains into the collector bottom. Air changes direction 180 degrees, air then enters the second stage HEPA type filter typically rated at a minimum 95% efficiency at 0.3 micron particle size. Ideally suited for production handlers machining for operations with water soluble, synthetic or mineral coolants. Oil Re-entrainment Eliminated Due to the unique internal design of the Monroe factories collector, the cleaned air will not re-entrain collected pollutants after the primary stage. This improves the efficiency of the air separation process and extends the life of the handlers optional final filters. The advanced design of the Monroe Spiral Tube Collector provides maximum mist and oil collection efficiency for in a mechanical collector.

The cartridges in the Monroe collector are mounted in factories a vertical position. This air assures that when the collected handlers dust is pulsed from the cartridges, it falls for to the bottom of the collector. factories In units with horizontal catridges, dust pulsed from above cartridges falls onto cartridges below. This reduces filtration capability and additional maintenance for rotating cartridge is necessary. This is avoided in the Monroe unit. The Monroe cartridges are easily accessed with pull out racks when replacement is air necessary. The Monroe Cartridge Dust Collector is available in capacities from 500 CFM to 50,000 CFM in handlers a single unit and may be integrated with existing ductwork and ventilation systems. An AMCA rated fan on the outlet side of the collector with either a direct coupled motor or an optional "V" belt for drive. Flexible duct connections, fan mounting isolators sound attenuators and fan closures are available. Integral Pressure Gauges are available to indicate when filter maintenance is required. Standard dust removal is via a slide gate. Options include rotary air locks or an integral screw conveyor. Complete electrical controls are availiable to meet customer requirements. Heavy factories gauge steel is used for most installations, but special construction materials are available to meet specific applications.

Recirculate air and handlers Clean Air In many installations, such as buffing and polishing, metal finishing and grinding foundry operations etc., it is possible to recirculate clean, contaminant-free air back to the work area. This reduces the cost of for plant ventilation systems and climate control needs. factories Proven High Efficiency Monroe Dual Throat Air Scubbers are currently operating continuously air and handlers at high efficiency in many types of industrial installations throughout the United States, Mexico and Canada. Cartridge cleaningis accomplished by reverse compressed air pulses through a few cartridges at a time, allowing continuous operation without shut-down. These reverse pulses, with a velocity of twice the speed of sound, break away caked dust from the cartridge so that it can drop the collector bottom. for Because of slower internal velocities through the collector, media factories replacement and maintenance labor costs are reduced. Collected air oil mist and solids are continuously drained from the media without shut-down, significantly prolonging filter life and lowering overall operating costs. handlers The Monroe Fiber Bed for Mist Collector removesparticles as fine as 0.3 micron. While normal filters permit these particles to re-entrain into the outgoing clean air, Monroe''s self-draining filter is designed to prevent oil re-entrainment and recirculate factories clean air to the atmosphere.