air purification at factories

The cartridges in the Monroe collector are mounted in air a vertical purification position. This assures that when the collected dust is pulsed from the cartridges, it falls to the bottom of the at collector. In units with horizontal catridges, dust pulsed from above cartridges falls factories onto cartridges below. This reduces filtration capability and additional maintenance for rotating air cartridge is necessary. This is avoided in the purification Monroe unit. at The Monroe cartridges are easily accessed with pull out racks when replacement is necessary. The Monroe Cartridge Dust Collector factories is available in capacities from 500 CFM to 50,000 CFM in a single unit and may be integrated with existing ductwork air and ventilation systems. An AMCA rated fan on the outlet side of the collector with either a direct coupled motor or an optional "V" belt drive. Flexible duct connections, fan mounting isolators sound attenuators and fan closures are available. Integral Pressure Gauges are available to indicate purification when filter maintenance is required. at Standard dust removal is via a slide gate. Options include rotary air locks or an integral screw conveyor. Complete electrical controls are availiable factories to meet customer requirements. air Heavy gauge steel is used for most installations, but special construction materials are available to meet specific applications.

Independent laboratory purification tests have shown that many of these units are removing various types of airborne pariculate at efficiencies up to 99.9%, even on heavy particulate at loads. A High Volume Water Injector The Monroe Dual Throat Air Scrubber utilizes a high volume wash water injector system that removes airborne particulate by delivering an initial surface inpingement shock to heavy inlet dirt loads. Dual Adjustable Scrubbing Throats High velocity atomization takes place as the inlet air is directed through the fixed and dual adjustable scrubbing throats. The easily adjustable dual throats balance the pressure drop through factories the air flow system at the start-up or after system changes are made. This design feature eliminates the need for ductwork dampers air and blast gates that are prone to particulate build-up and require periodic maintenance. In addition, the increase in pressure drop in the wash zone purification and at improves the overall effciency of the system. After passing through the turbulent factories dual throat wash zone, the air inpinges air on the liquid purification surface, changes direction and then continues through deflectors and to a large, double row moisture eliminator section. Water droplets in the at airstream are removed factories and drain back to the wash liquid reservoir tank. The clean, dry air is then recirculated to the work area or discharged through exhaust ducts.